Toyota Previa 96 - Brake Pads / Cupholder

[malcuk]

Hi all.

Wondered if anyone could point me to a decent site that sells pads front and rear for my Previa ?.

Its a 96 GX model, and the Toyota parts are
Front brake pads original part no 04465-28040 and optifit part no 04465-YZZAK
 
Rear brake pads original part no 04466-28090 and optifit part no 04466-YZZC7

but these cost a bomb, and am looking for decent quality alternatives, have scoured ebay etc.

*****************

Also one thing I have been after for ages is the in dash cup holder that was equipped on the USA previa but not the UK model.

I have seen another site suggesting part numbers
55615-95D00 A1 and  55633-95D00 A1

but the official toyota number is 5560495DOO 17 costing £37.06 + VAT which is too much for my budget (

Many thanks for any help you can give, and if not, will keep looking 

[Kernowman]

I use ebay.... Bellocat sell a lot of estima/previa spares and a few other sellers.
Contact them thru ASK QUESTION button and give your part numbers there so they can match them up.. 

Failing that, give GT Motors a ring.. number on banner at top of forum index page.

[malcuk]

thank you, I will go take a look, have been sending messages to ebay sellers in USA also re. cupholder, so fingers crossed !

[mr mince]

thank you, I will go take a look, have been sending messages to ebay sellers in USA also re. cupholder, so fingers crossed !

Think wide body Estimas also had the cup holder and there were quite a few of them imported here, might be worth a look around the breakers see if there's any, biggest problem is I doubt most of the breakers will be able to tell the difference between a wide body Esti and  a Previa they certainly have enough trouble working out the narrow Esti is different.

[Kernowman]

Can't remember seeing the cupholder in the M reg previa. It had a tray on passenger side.
The Estima has the pull out cupholder built into dash.. maybe you should think about trying to fit one of those in. 

[ADarbon]

you can get a pull out one for the previa some one put up a post about it some time ago

[Kernowman]

I'd go with giving Gary at GT Motors a ring and seeing what he has in stock. 

[malcuk]

Will keep trying and let you know when I get some success, thanks guys 

[mr mince]

Can't remember seeing the cupholder in the M reg previa. It had a tray on passenger side.
The Estima has the pull out cupholder built into dash.. maybe you should think about trying to fit one of those in. 

Jap and American versions only as far as I remember, they obviously didn't trust us with hot stuff at the wheel